Spacing for silicone in Eurobrace

craiginphoenix

Community Member
View Badges
Joined
Jan 3, 2022
Messages
80
Reaction score
54
Location
Phoenix AZ
What state or country do you live in
Arizona
Rating - 0%
0   0   0
So I created this thread on a Red Sea G1 525 XL I was given for free, and wanting to add additional support to the seams, and it didn't get much traction. It's a working tank with no seam issues currently but was looking to add additional support before filling and using it.

Anyway, I have decided to ignore everything I said there and add eurobraces to the top and bottom of my tank, but I am not sure how much space I should allocate between the glass cuts for silicone.

The tank itself seems to have 1/8 inch spacing so I was planning to have the same spacing beween the glass and the tank, but what about the pieces of glass themselves? Should I leave no spacing?

Leaving 1/8 of an inch, specifically between the glass cuts themselves, seems like a lot. Especially on top because I will be putting them in the tank and not have them sitting on top.

Should there be no spacing between the glass itself? Smaller spacing?
 
So I created this thread on a Red Sea G1 525 XL I was given for free, and wanting to add additional support to the seams, and it didn't get much traction. It's a working tank with no seam issues currently but was looking to add additional support before filling and using it.

Anyway, I have decided to ignore everything I said there and add eurobraces to the top and bottom of my tank, but I am not sure how much space I should allocate between the glass cuts for silicone.

The tank itself seems to have 1/8 inch spacing so I was planning to have the same spacing beween the glass and the tank, but what about the pieces of glass themselves? Should I leave no spacing?

Leaving 1/8 of an inch, specifically between the glass cuts themselves, seems like a lot. Especially on top because I will be putting them in the tank and not have them sitting on top.

Should there be no spacing between the glass itself? Smaller spacing?
I’ve found that around 3/32” air gap between glass pieces is ideal to inject silicone into; not too narrow to inject, not a gaping wide slot!

This means each glass piece would be cut 3/16” short of exact dimensions to accommodate for 3/32” of air gap at each end! (Assuming both ends of the piece in question are being put in a blind corner where injection silicone is mandatory, vs. just laying a bead and setting the glass in place!)

Around 1mm-1.5mm of seam thickness appears to be the happy place for most seams where you’re just laying a bead and placing the glass!
 
Upvote 0

TOP 10 Trending Threads

HOW WOULD YOU FEEL ABOUT RECEIVING A FISH OR CORAL AS A HOLIDAY GIFT?

  • I’d love one, as long as it’s a species I chose

    Votes: 5 50.0%
  • I’d trust someone who knows my tank to choose

    Votes: 0 0.0%
  • I’d rather get a gift card and pick it myself

    Votes: 3 30.0%
  • I’d prefer gear or supplies instead

    Votes: 0 0.0%
  • Please don’t surprise me with livestock

    Votes: 2 20.0%
  • Other (Post in the comments)

    Votes: 0 0.0%
Back
Top
Home
Post thread…
Market
What's new