stirring chemical.. which ones?

  • Thread starter Thread starter CEReefer
  • Start date Start date
  • Tagged users Tagged users None

CEReefer

Well-Known Member
View Badges
Joined
Sep 7, 2019
Messages
589
Reaction score
317
What state or country do you live in
Ohio
Rating - 0%
0   0   0
I am designing the cabinet of my new tank, and I would like to know what kind of additives actually require stirring (every so often or more frequently) or if there is any additive which should definitely NOT be stirred?
 
Very few additives require stirring. Those that do are slurries of solids in water. Anything that is fully dissolved chemical needs no stirring.

None are hurt by stirring, unless that heats them up substantially.

What are you dosing?
 
I am planning on dosing the classic 2 part + trace elements, as I said in a previous post, I am debating between ESV + trace or BRS/TM with trace elements. I also dose vinegar. I asked because now I am dosing red sea Alk/Ca and found that they are pretty tick and tend to settle a bit
 
I am planning on dosing the classic 2 part + trace elements, as I said in a previous post, I am debating between ESV + trace or BRS/TM with trace elements. I also dose vinegar. I asked because now I am dosing red sea Alk/Ca and found that they are pretty tick and tend to settle a bit

Alk and calcium additives do not settle out if made properly and do not require stirring.

Some alkalinity additives are near their solubility limit, and if they get cold, can precipitate. The solution is not stirring during dosing, but warming it up to redissolve, or adding more water, if needed.

Typically, some alk and calcium solutions may have a small amount of fine solid precipitates which are impurities, not what you want to dose.
 
Alk and calcium additives do not settle out if made properly and do not require stirring.

Some alkalinity additives are near their solubility limit, and if they get cold, can precipitate. The solution is not stirring during dosing, but warming it up to redissolve, or adding more water, if needed.

Typically, some alk and calcium solutions may have a small amount of fine solid precipitates which are impurities, not what you want to dose.
My containers of Alk and Ca from red sea (A and B). Always had some sediment, I always shake it to “make it dissolve”. I didn’t know they were impurities, I will now stop doing that then
 
My containers of Alk and Ca from red sea (A and B). Always had some sediment, I always shake it to “make it dissolve”. I didn’t know they were impurities, I will now stop doing that then

That sounds best. :)
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 17.7%
  • Fish or coral food

    Votes: 5 5.2%
  • Test kits or reagents

    Votes: 10 10.4%
  • Filter media or replacement fleece

    Votes: 5 5.2%
  • RO/DI filters or supplies

    Votes: 15 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 12 12.5%
  • I keep a backup of everything

    Votes: 25 26.0%
  • Other (Post in the comments)

    Votes: 7 7.3%
Back
Top
Home
Post thread…
Market
What's new