I have been dosing Stump Remover for the last 2 months to raise nitrate levels from 0 to 5-10. I recently got back my ICP test results back and showed the following:
1. High reading of Potassium 493 mg/l vs 400 mg/l. µg
2. Lithium was detected 254 µg/l vs 200 µg/l
3. Molybdenum levels were high 26 µg/l vs 12 µg/l
Should I look into switching to pure reagent grade?
I dose the following in my system (mixed reef):
1. Stump Remover
2. Seachem Flourish Phosphorus - to keep phosphate levels between .02-.05
3. Acro Power
I am not sure if Acro Power can be the culprit but I am almost considering to stop dosing this as I have not seen any difference.
Any feedback is appreciated.
1. High reading of Potassium 493 mg/l vs 400 mg/l. µg
2. Lithium was detected 254 µg/l vs 200 µg/l
3. Molybdenum levels were high 26 µg/l vs 12 µg/l
Should I look into switching to pure reagent grade?
I dose the following in my system (mixed reef):
1. Stump Remover
2. Seachem Flourish Phosphorus - to keep phosphate levels between .02-.05
3. Acro Power
I am not sure if Acro Power can be the culprit but I am almost considering to stop dosing this as I have not seen any difference.
Any feedback is appreciated.