Systemic coral death, HELP

Agreed. If those are smaller lights, then you should have a 12 hour day and they should run at 100% all day....util you get lights sized for the tank.

Sounds like the person helping with your tank may have had upgrade plans across the board for this tank. 👍
 
In a span of a week, many of my corals have died suddenly.

Last week, a giant torch that has been in the tank for over 4 months died within three days, losing many tentacles a day, leaving only a brown stump.

My hammer coral followed the same process a few days later and now it's gone.

This morning I awoke to find the skin peeling off my Jack O Lantern, exposing white skeleton below. I also noticed a small white worm travelling along the edge so perhaps this is the culprit?

I'm also noticing webbing hanging off some of the corals, I have no idea what's going on!

Nothing has been added to the tank for over 2 months.

Temp: 77-78

Ammonia: 0 ppm

Nitrite: 0 ppm

Nitrate: ~20 ppm

pH: 8.2

Alkalinity: 9 dKH

Calcium: 400 ppm

Magnesium: 1,200 ppm

Salinity: 1.025
Sounds like a pest or infection problem, not water chemistry. Your parameters look solid, and nothing new has gone in for two months.

Most likely causes:

  • Flatworms or nudibranchs: That white “worm” on the Jack O Lantern is a prime suspect. Some species eat LPS corals like torches and hammers and can strip them in days.
  • Brown jelly: Rapid tissue meltdown with stringy brown slime is common on torches and hammers, and it spreads fast.
  • The webbing: Likely mucus from stressed corals, or pest-related.
What to do now:

  1. Move the affected corals into a separate container and inspect them with a flashlight.
  2. Dip them in a coral dip, following the label, then rinse and keep them in quarantine.
  3. Remove dead tissue and skeletons from the tank right away.
  4. Do a 15-20% water change and run fresh carbon.
  5. Post a close-up photo of the worm on a reef forum for an ID.

Your numbers look good. I’d nudge calcium up toward 420 ppm, but that’s not what’s killing your corals.
 
One challenging thing about torches is they something just melt away seemingly without any apparent cause or warning. People postulate that this can be caused by a bacteria infection which leads to or accompanies brown jelly disease. I have had growers recommend running UV on any systems with a large Euphillyia load to help prevent this from happening. Unclear whether this is the issue you may be facing.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.7%
  • Fish or coral food

    Votes: 5 5.5%
  • Test kits or reagents

    Votes: 9 9.9%
  • Filter media or replacement fleece

    Votes: 5 5.5%
  • RO/DI filters or supplies

    Votes: 14 15.4%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.0%
  • I keep a backup of everything

    Votes: 24 26.4%
  • Other (Post in the comments)

    Votes: 7 7.7%
Back
Top
Home
Post thread…
Market
What's new