T slot experts? Connectors?

[iReefer12]

I’m looking to build a mount to house several Power Supply bricks.

I’ve attached a drawing, I’m looking to try and mount a 2080 strip to the wall, then use 2080 sideways for the power brick to sit on. Is there a fastener that connects Side slot to Face? It’s really hard to explain, so hope the picture helps.

 

[Reefer Reboot]

Are you dead set against using a L-shaped 90 degree bracket under the horizontal beam?

 

[iReefer12]

Yeah, but I think I’ve come up with a solution. Use the corner bracket on the sides, this keeps the horizontal surface flat and smooth.

see attached. I think this should work?

 

[Reefer Reboot]

If you go with this type,

You'll have to file off the little locating tabs on one side, easy to do.
There is also this type if you don't mind doing a little machining.

 

[iReefer12]

I don’t trust myself to do the machining, I think I’ll stick to the corner strategy. I’ll post the result here. Thinking this will look clean and also allow heat to sink away from the bricks.

 

[servus]

Watching this, looking at similar build.

 

[iReefer12]

I ordered some 2040 on eBay, will be here in Feb so I’ll post some pics here once it arrives.

 

[iReefer12]

The T Slot arrived. I think this could work quite well. (I would order the longer version to act as the post.) just ordered short to test, but it’s also the right side for the shelf pieces.