tds meter questions

install the "IN" side after your carbon blocks and filters but before your DI chamber. The "OUT" side needs to be after the membrane and DI. That way you will be able to see when it is time to replace you filters and DI separately.
 
Mike was talking about a dual in line setup TDS metering system, Is yours just a hand held? If so rinse in tap water after each use unless the instructions tell you other wise.
 
Sorry, been used to the inline for so long I have forgotten they make any other kind....
 
I think you'd use it like you would a thermometer. Poke the probe in the water and read the numbers.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.7%
  • Fish or coral food

    Votes: 5 5.5%
  • Test kits or reagents

    Votes: 9 9.9%
  • Filter media or replacement fleece

    Votes: 5 5.5%
  • RO/DI filters or supplies

    Votes: 14 15.4%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.0%
  • I keep a backup of everything

    Votes: 24 26.4%
  • Other (Post in the comments)

    Votes: 7 7.7%
Back
Top
Home
Post thread…
Market
What's new