coastal_kid
Community Member
My MP40 is not working and I want to determine if the controller is at fault, or if the motor is bad.
I've opened the cover on the controller and unplugged the molex connector to the motor.
I would like to use my adjustable power supply to send a current to the motor to see if it runs.
I can't find a wiring diagram.
Which pins/wire should I apply the + and - power to?
I've opened the cover on the controller and unplugged the molex connector to the motor.
I would like to use my adjustable power supply to send a current to the motor to see if it runs.
I can't find a wiring diagram.
Which pins/wire should I apply the + and - power to?
