Good morning,
I have a Tunze 3155 that has started to fail. During the past week I found the return chamber in the sump almost dry. On the Tunze controller the low level light was blinking but the pump didn’t turn on. But if I unplug the power when it turns back on, the water starts to fill up but it doesn’t stop until it reaches the backup float sensor. Then the high level light starts blinking. Is there anything I can do to fix that issue.
thanks in advance.
I have a Tunze 3155 that has started to fail. During the past week I found the return chamber in the sump almost dry. On the Tunze controller the low level light was blinking but the pump didn’t turn on. But if I unplug the power when it turns back on, the water starts to fill up but it doesn’t stop until it reaches the backup float sensor. Then the high level light starts blinking. Is there anything I can do to fix that issue.
thanks in advance.