Tunze nano ato

  • Thread starter Thread starter Reef.
  • Start date Start date
  • Tagged users Tagged users None

Reef.

5000 Club Member
View Badges
Joined
Mar 12, 2019
Messages
5,364
Reaction score
3,908
Rating - 0%
0   0   0
Not sure what I’m doing wrong, the pump was working, I removed it for a water change, doesn’t work now, will work with the black tubing disconnected but when I connect it, it stops pumping water, still making a pumping noise, just no water coming out, the height to the tank is only a few cm.

I think the tubing may be getting blocked when I push it in the connection? Do I just push the tubing into the outlet hole on the pump? Or am I missing something?

Thanks.
 
Sorted! a good suck on the end did the tick.
 
They are notorious for getting air stuck in the pump when they are pulled out of water. Easier way is to turn the pump on its side and shake it a bit to get the air bubbles out. I stopped using mine on my reef tank due to this and only use it on my FW Planted tank now, which isn’t dire since no salt level to maintain, only water level.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new