I have 3 6020s, 2 of which keep locking up on start up (I run them in 3 hour intervals to mix up the stream using an apex classic).
It appears that on start up the water flow jams them into the bushings.
I replaced the bushings and props thinking that was the issue, but it continues, I have to stick my finger in their to free them up and finesses them to freely spin. Additionally, If I pull them out of the water I can get them and slowly submerge them and they wont lock up.
So I have to keep these on and then manually turn the off and then back on when I feed (defeating the feed program in the apex and limit my ability to change the flow).
I do clean them regularly (2x month).
any troubleshooting ideas to get these to work as designed?
It appears that on start up the water flow jams them into the bushings.
I replaced the bushings and props thinking that was the issue, but it continues, I have to stick my finger in their to free them up and finesses them to freely spin. Additionally, If I pull them out of the water I can get them and slowly submerge them and they wont lock up.
So I have to keep these on and then manually turn the off and then back on when I feed (defeating the feed program in the apex and limit my ability to change the flow).
I do clean them regularly (2x month).
any troubleshooting ideas to get these to work as designed?