Vectra M1 - No Lights on Controller

CCK_8814

2500 Club Member
View Badges
Joined
May 22, 2018
Messages
4,092
Reaction score
1,635
Location
Detroit
Rating - 95.6%
42   2   1
So I was in the middle of doing the min/max speed calibration on my M1 when the tank started to fill too much to the point of almost overflowing so I quickly killed the power to the pump. Since then I cannot get any lights on the controller to come on. I pulled the controller apart to see if maybe water managed to get into the board but it’s completely dry. Holding down mode/set doesn’t do anything. Anyone have any ideas?
 
So I was in the middle of doing the min/max speed calibration on my M1 when the tank started to fill too much to the point of almost overflowing so I quickly killed the power to the pump. Since then I cannot get any lights on the controller to come on. I pulled the controller apart to see if maybe water managed to get into the board but it’s completely dry. Holding down mode/set doesn’t do anything. Anyone have any ideas?
Just log the ticket with ecotech support. They'll figure it out or for a $1 will send you a new controller,
 
Just log the ticket with ecotech support. They'll figure it out or for a $1 will send you a new controller,
After it sat for a few days I took another look inside the controller at the board and a small amount of corrosion had appeared on the contacts of the power supply connector. I was able to unsolder the connector, clean the corrosion, apply some dielectric grease then reinstall the connector. It is back to working perfectly.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new