Vectra S2 Calibration

[Floyd_UK]

Afternoon,

I have jsut purchased the Vectra S2 and have watched the calibration videos. Maybe I am just not understanding, but when I select feed mode the tank drains as though the pump is off.

I was under the impression that the minimum flow would keep the weir full, am I correct?

The calibration videos suggest minimum is just a trickle.

The pump is in return mode.

Many thanks in advance

 

[SPR1968]

I can’t help with the question, but I can bump the thread to see if we can get you some assistance

 

[SPS2020]

Afternoon,

I have jsut purchased the Vectra S2 and have watched the calibration videos. Maybe I am just not understanding, but when I select feed mode the tank drains as though the pump is off.

I was under the impression that the minimum flow would keep the weir full, am I correct?

The calibration videos suggest minimum is just a trickle.

The pump is in return mode.

Many thanks in advance

Did you get this resolved? I'm having an issue with setting the low flow to a trickle.

 

[Idech]

Just in case someone is wondering, the minimum flow is what you make it when you calibrate. I don’t see why anyone would set it to high flow, so it’s minimal flow.

Feed mode is supposed to use this minimum flow setting. So yes, the overflow box will empty when using feed mode.

I have not been able to use feed mode without it undoing all my flow settings and having to do it all over again. I tried many times. On the other hand, if I just lower the flow setting with the dial and put it back where it was manually, then it goes back to pretty much what it was.

There seems to be a problem with the feed mode. I need to do more research on that.

 

[aggrofish]

ive honestly never even bothered I just use the feed mode on the mP40s/10s