Vertex RX-C 6D + Kamoer FX-STP: Bubble trapped

  • Thread starter Thread starter CivicS14
  • Start date Start date
  • Tagged users Tagged users None

CivicS14

Well-Known Member
View Badges
Joined
Jul 5, 2017
Messages
572
Reaction score
633
Location
Stone Mountain, GA
What state or country do you live in
Georgia
Rating - 0%
0   0   0
Hi All,

I use to have my Vertex plumped into a sicce 1.0 that fed my carbon & gfo reactor and never had issues with air being trapped in this reactor because I could run it wide open and it would clear in a few minutes if it ever did happen.

Now, I added a Kamoer FX-STP pump to get a consistent flow rate and I can't seem to get the air out of the reactor. Before, I can run it wide open and it would clear the air, but with the kamoer and 120ml/min max flow, it seems like it's not enough flow to clear it.

Any suggestions or inputs? This loud gurgling noise is driving me insane.
 
You can always pop the line at the top of the reactor to purge the air. I feed mine off my manifold with a steady high flow drip back into my sump and adjust the ph with a controller to vary the output. my air bubbles from the co2 tank isnt as important t that way and the air(co2) wont get trapped bc its moving at a higher rate.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.7%
  • Fish or coral food

    Votes: 5 5.5%
  • Test kits or reagents

    Votes: 9 9.9%
  • Filter media or replacement fleece

    Votes: 5 5.5%
  • RO/DI filters or supplies

    Votes: 14 15.4%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.0%
  • I keep a backup of everything

    Votes: 24 26.4%
  • Other (Post in the comments)

    Votes: 7 7.7%
Back
Top
Home
Post thread…
Market
What's new