I came across a fellow reefer who wasn't using a WB tank that had some slight chips and decided to set up a Frag tank, I tried setting up an IM15g as a frag tank but it became more of a chore so I decided that I needed to plumb any frag tank into my main tank for any stability. I had leftover 3/4" plywood laying around so off to building! First off was to water test the WB to see if it indeed holds water, second to have it drilled for external overflow, ended up using a Fiji over box rated for 600g. I wanted to make this as simple as possible so I plumbed the drain into the return section of my sump, to feed the tank I just redirected the output of my UV and carbon reactor. PLumbing long distances always worry me since leaks could always happen in the worst spots but luckily everything went off without a hitch!
Once setup I immediately noticed that the Fiji overflow box was louder than my 290g! To remedy this I added a gate valve on the drain. For lighting, I first tried a NP K7 and it was adequate but not satisfying. I was planning to take down my Reefi Uno's from my main tank since switching back to halides and decided to put 1 of the Uno's on the frag tank. I feel more confident with the Uno since I had them over my main tank and they do a nice job.
Here are a few pictures to start!
Once setup I immediately noticed that the Fiji overflow box was louder than my 290g! To remedy this I added a gate valve on the drain. For lighting, I first tried a NP K7 and it was adequate but not satisfying. I was planning to take down my Reefi Uno's from my main tank since switching back to halides and decided to put 1 of the Uno's on the frag tank. I feel more confident with the Uno since I had them over my main tank and they do a nice job.
Here are a few pictures to start!