WaveEngine v2 stuck in feeding mode

BryanM · Feb 19, 2026

Title says it all, if I try and click to normal its "faded", and just automatically goes back to feeding mode. I suspect that's why the lights are breathing white as well, but I'm not sure.

Dread Pirate Dave · Feb 19, 2026

If it was me, I would try adding or editing a mode and upload the changes. Then see if you can change selection. Hopefully that unsticks it.

Shawnfish1122 · Feb 19, 2026

Dread Pirate Dave said:
If it was me, I would try adding or editing a mode and upload the changes. Then see if you can change selection. Hopefully that unsticks it.

JeffB418 · Feb 20, 2026

1) check if you have voltage triggering enabled. go to the left menu -> options -> mode control input. This should be NONE unless you are using something like a button box.
2) if you are using something to trigger modes, make sure you have the input voltage set correctly under each mode. also check exit delays and mode timeouts
3) if issue isnt resolved, hit up [email protected]

Mr. Mojo Rising · Feb 20, 2026

Not sure if you tried a reboot (unplug count to 10 and plug back in)? I find the WE or hydros gets buggy after a few months (lights don't turn on or else stay on and don't turn off, gyres unresponsive to commands, etc...), a quick reboot has always fixed any bug for me. But anyhow, coralvue has amazing customer service if you submit a ticket

BryanM · Feb 20, 2026

JeffB418 said:
1) check if you have voltage triggering enabled. go to the left menu -> options -> mode control input. This should be NONE unless you are using something like a button box.
2) if you are using something to trigger modes, make sure you have the input voltage set correctly under each mode. also check exit delays and mode timeouts
3) if issue isnt resolved, hit up [email protected]

It was enabled, and it was previously being used, but not anymore.

Thank you!