Will using a higher alk salt increase ph?

  • Thread starter Thread starter Reef.
  • Start date Start date
  • Tagged users Tagged users None

Reef.

5000 Club Member
View Badges
Joined
Mar 12, 2019
Messages
5,364
Reaction score
3,908
Rating - 0%
0   0   0
I keep my tank just above 7dkh if I were to move to 8dkh would that increase my ph?

I’m asking as I have just tested my fresh salt mix, (stored for 2 weeks) the alk is 8dkh and the ph is 8.4, yet my tank is 7.3dkh with a ph of 8, I’m guessing these parameters are not really only down to the differences in alk
Lvls but because I’m comparing a tank parameter to a bucket of fresh salt mix?
 
Yes but slightly
Sodium bicarbonate also effective
 
Very slightly , just get a co2 scrubber and live a happy life!!
 
Yes but slightly
Sodium bicarbonate also effective
Was thinking it wouldn’t make up the 0.4 difference, wishful thinking I guess!

Was surprised the ph in my fresh salt mix was as high as it was, seeing it’s in a container with a lid and no water movement?
 
pH in our tanks is only a function of alkalinity and CO2.

The freshly mixed stuff has higher alk, but also doesn't have as much CO2 dissolved in it yet.

Sodium bicarbonate (baking soda) will raise alk and temporarily lower pH.

Edit: I forgot to mention, I wouldn't increase alk above natural seawater levels to try to obtain higher pH.
 
pH in our tanks is only a function of alkalinity and CO2.

The freshly mixed stuff has higher alk, but also doesn't have as much CO2 dissolved in it yet.

Sodium bicarbonate (baking soda) will raise alk and temporarily lower pH.

Edit: I forgot to mention, I wouldn't increase alk above natural seawater levels to try to obtain higher pH.
Right that makes sense, thanks.

Co2 plays a bigger roll than I was giving it credit for.
 
Can you see this chart? It's from an older article by @Randy Holmes-Farley :
1639169674879.png


It's in meq/L instead of dKH, but you might be able to guess how much alk increase it would take to raise pH to where you want it. Or it might be a fool's errand.
 
Can you see this chart? It's from an older article by @Randy Holmes-Farley :
1639169674879.png


It's in meq/L instead of dKH, but you might be able to guess how much alk increase it would take to raise pH to where you want it. Or it might be a fool's errand.

8.4dkh for ph of 8.3 if I have read the graph correctly.
 
Do search of this forum for low pH, to see what factors are involved beyond alkalinity. Ventilating to reduce CO2 in the indoor air.

And, not sure if this really works, there is AquaVitro additives "eight.four" and "balance" for increasing pH without increasing alkalinity.

And there were threads about aragonite sand pulling pH down, comparing to inert substrates. Seachem experimented with this too, in their Articles, marine pH and substrates.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.1%
  • Fish or coral food

    Votes: 5 5.3%
  • Test kits or reagents

    Votes: 10 10.6%
  • Filter media or replacement fleece

    Votes: 5 5.3%
  • RO/DI filters or supplies

    Votes: 15 16.0%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 11 11.7%
  • I keep a backup of everything

    Votes: 24 25.5%
  • Other (Post in the comments)

    Votes: 7 7.4%
Back
Top
Home
Post thread…
Market
What's new