2 pH Probes and CaRx code question

BPiers · Jan 15, 2016

First time using 2 pH probes. One for the main tank (pH), the other in my Calcium Reactor (pH2)

I thought I could have the CO2 solenoid be controlled by pH2, but I'm having issues uploading the code. I want the switch to be naturally OFF, but on as long as the pH within the CaRx is no less than 6.4, when the solenoid will shut off until the pH rises again.
The Feed D is my maintenance feed, with a 5 minute defer statement.

I get the error with the pH2, even though it is a prompted line when writing the statement.
What am I doing incorrectly?

Fallback OFF
if pH2 > 6.41 Then ON
if pH2 < 6.4 Then OFF
If FeedD 000 Then OFF
Defer 005:00 Then ON

jduck · Jan 15, 2016

What error did it give?

BPiers · Jan 15, 2016

Send Failed

//Error: line 2 - Valid keywords following If are Temp, pH, ORP, DO, Cond, Par, Feed, SwX, Error, Power, Sun, or Moon // If pH2 > 6.41 Then ON //Error: line 3 - Valid keywords following If are Temp, pH, ORP, DO, Cond, Par, Feed, SwX, Error, P

it looks like pH2 is an Invalid keyword? Even though this is the name of a secondary probe?

evolved · Jan 15, 2016

Try "pHx2" instead

BPiers · Jan 15, 2016

Negative. Same error :/

evolved · Jan 15, 2016

What is the probe actually named as on the Probe/Input setup under the Configuration tab?
And is it enabled there?

BPiers · Jan 15, 2016

pH2.

Screen Shot 2016-01-15 at 1.19.16 PM.png

BPiers · Jan 15, 2016

To test something, I added a set of lines in my email alarm for the same probe, pH2 and get the same upload error:

Send Failed

//Error: line 8 - Valid keywords following If are Temp, pH, ORP, DO, Cond, Par, Feed, SwX, Error, Power, Sun, or Moon // if pH2 > 6.6 then ON //Error: line 9 - Valid keywords following If are Temp, pH, ORP, DO, Cond, Par, Feed, SwX, Error, Po