24vdc to 12V? roller mat

[becon776]

Hey guys,
So retrofit a trigger platinum 34 into my rsr450. Love the wide butt media so far and has been working well.
Only thing is that the power plug is awkward and bulky to fit into eb8 also I have no open outlets. So jist plugged right into wall.
I'd Love to come up with a clean solution to run this 12V motor/board to the 24 v outlets since i have 5 and they are all sitting empty.
Just dont know best way to do this and have it look clean at same time.
Any ideas? i kniw we have to have some electronics ninjas on this forum!

 

[Sisterlimonpot]

All you need is a 24v to 12v converter, you can find them on Amazon

 

[58e970b2-3f88-4897-87ba-5]

Not an electronics ninja, but this might be a place to start looking:
https://en.m.wikipedia.org/wiki/Buck–boost_converter

You can find them on Amazon. I have used them before to adjust 12v fans down to a reasonable noise level / voltage.