33 ppt = 1.026 sg???

johnf3

Community Member
View Badges
Joined
Sep 14, 2023
Messages
77
Reaction score
31
Location
Los Angeles
What state or country do you live in
California
Rating - 0%
0   0   0
Hi all

For the past couple years I’ve only been using my good old refractometer and calibrating it with 35ppt solution to measure my salinity in tanks and when mixing water. It has always worked well for me and is my standard for mixing water. Well recently I purchased the Hanna marine salinity tester and once I’ve calibrated it with its 35ppt solution it says all of my water is 33-33.5. The same water shows a perfect 1.026 on my refractometers. I called Hanna and they sent an essay on the differences between conductive and refractive salinity measurement, I get that there will always be a bit of discrepancy seeing that they are measuring salinity in two totally different ways. I’m just curious if I should try to raise all of my tanks and new water closer to 34/35 on the Hanna tester or just stick it out with my refractometer and use the Hanna knowing it is reading 2 below my refract? All tank inhabitants seem to be fine so I’m leaning towards just leaving as is but wanted to get someone else’s opinion as 33 ppt seems like it’s just about too low
 
i would just go by the refractometer. I don’t trust Hanna anymore, at least for the salinity checker. I had one fail just after only 1 year. I now use tropic Marin’s hydrometer
 
Honestly pick one method and stick to it. If it is wrong at least you are going to be consistently wrong.

I use this:
1715107082285.jpeg

No calibration required.

When I do my ICP test the lab measures salinity and it is inline with my method so good enough for me.

Good luck,
 
Thanks for the insight guys! I’ll have to check out this tropic Marin hydrometer
 
I have 2 Hanna marine salinity testers and found that it's critical to calibrate fairly often. That being said, they are super easy to use and very accurate when callibrated accuratly.
 

TOP 10 Trending Threads

WHICH PART OF YOUR SETUP IS HARDEST TO REACH OR REMOVE FOR ROUTINE MAINTENANCE?

  • Glass behind or beside the tank

    Votes: 2 13.3%
  • Powerheads or wavemakers

    Votes: 2 13.3%
  • Sump or rear filtration chambers

    Votes: 2 13.3%
  • Skimmer or other filtration equipment

    Votes: 1 6.7%
  • Overflow or plumbing

    Votes: 5 33.3%
  • Lights or lids

    Votes: 0 0.0%
  • Mine is pretty easy to access!

    Votes: 2 13.3%
  • Other—tell us what I missed

    Votes: 1 6.7%
Back
Top
Home
Post thread…
Market
What's new