...not that this is genius or anything, but it is what I came up with since $60 seemed ridiculous. Hope that it helps somebody.
3' 1/4 Aluminum Rod - Lowes, Home Depot or your local Hardware Store should have these. Mine was $3.99.
4 or 5 Small Zip Tips
Hammer
Anvil or Vise
Drill and Bit
Get your anvil and BFH (that is Big Friggin' Hammer) and beat the end flat and then bend it. Work fast with the hammer since it will heat the aluminum up a bit and it will be easier to flatten. Drill a hole and then zip tie on the sensor. Clean the workbench gunk off of it and then you are all good.
3' 1/4 Aluminum Rod - Lowes, Home Depot or your local Hardware Store should have these. Mine was $3.99.
4 or 5 Small Zip Tips
Hammer
Anvil or Vise
Drill and Bit
Get your anvil and BFH (that is Big Friggin' Hammer) and beat the end flat and then bend it. Work fast with the hammer since it will heat the aluminum up a bit and it will be easier to flatten. Drill a hole and then zip tie on the sensor. Clean the workbench gunk off of it and then you are all good.