6105 Frayed Wire

[Robs Reef]

Any way I can get this fixed with some kind of heat shrink tubing? Still works great, just scared of any electrical shock, since its always submerged. Any help woold be greatly appreciated. Just kind of odd, where the breaking point is, just feels so brittle.

thanks

Rob

 

[FUNGI]

Cut where wire is NOT submerged, put on a shrink tube, re-solder the cut of wires (and heat shrink), then you'll need to heat shrink and apply epoxy and make sure epoxy goes into the hole aswell.

 

[ingchr1]

I would not perform your own repair yet. Wait to hear from Tunze first.

 

[rvitko Verified Sponsor]

Most likely this cable is from a defective batch from a cable supplier we quit using, I would not recommend repairing the cable. Can I get a photo of the date stamp on the pump, it is 4 digits pressed into one of the long sides of the hexagonal body the impeller seats in? It is pressed in with a hot iron and melted into the plastic.

 

[Robs Reef]

Most likely this cable is from a defective batch from a cable supplier we quit using, I would not recommend repairing the cable. Can I get a photo of the date stamp on the pump, it is 4 digits pressed into one of the long sides of the hexagonal body the impeller seats in? It is pressed in with a hot iron and melted into the plastic.

0317

this should be it.

 

[rvitko Verified Sponsor]

Just sent a message.

 

[Robs Reef]

Just sent a message.

Replied, Thank You so much!