Adding all Trace Elements to Magnesium (Component C)?

  • Thread starter Thread starter Coling
  • Start date Start date
  • Tagged users Tagged users None

Coling

Active Member
View Badges
Joined
Nov 3, 2016
Messages
160
Reaction score
135
Rating - 0%
0   0   0
Reefers,

I had been dosing Aquaforest Components 1+2+3+ but recently started dosing kalkwasser. The kalk has been able to keep up with my calcium and alkalinity demand but I would like to dose magnesium in trace elements as well. Can I just dose the kalkwasser in conjunction with Component 3+ (Magnesium and Component K) and add the other trace elements (Components A, B and C) that are supposed to be dosed with Components 1+ and 2+ into the Component 3+ container?

Thanks for your time!

Cheers,

Colin
 
I’m not sure what you are asking. Not all trace elements are soluble in kalkwasser. Magnesium (not a trace element) is certainly not stable in kalkwasser.
 
Sorry if I didn't articulate that very well.

I am asking if I can dose all trace elements (Aquaforest Components Strong) combined with magnesium from one container/dosing pump.

I have been dosing Component 1+ (Ca, Sr, Ba, Co, Mn, Cu, Fe, Zn, Ni, Cr), Component 2+ (NaHCO3, F, I) and Component 3+ (Mg, Reef Mineral Salt, K and B) but no longer need the Ca and NaHCO3 as I am getting that from kalkwasser. Just wanted to see if I can dose the Sr, Ba, Co, Mn, Cu, Fe, Zn, Ni, Cr, F and I with Component 3+ rather than having to dose from 3 dosing lines/containers in addition to the kalk (I am constantly dripping kalkwasser with a stepper pump).

Or if I could add those elements to the kalk that would be convenient too.
 
I would advise first that using the part three of a three part when not using calcium chloride likely won’t be ionically balanced long term as it likely contains a lot of sulfate to offset the chloride. Net effect will be rising sulfate and falling chloride. It’s ok for a bit, but not a permanent method.

Some trace metals may precipitate from kalkwasser.

Any trace element that you can put into a calcium part can be put in a magnesium part. Trace elements that aren’t stable in calcium won’t be stable in the magnesium.

I do not know what forms of these trace elements any given company uses, so giving advice beyond that is tricky.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new