Hi All!
As stated, I'm running into an issue where I've obviously screwed up the programing on my AFS, and it is spinning every 30 seconds (don't worry, I moved it over a paper plate until I figure this out). I'd like to have all of my pumps, skimmer, ATO, etc. turn off when the feeding cycle starts and stay off for either 5 or 8 minutes after feed cycle is complete. I need the AFS to spin 3 times for each feeding and was using the OSC command, but I'm sure I've messed up somewhere. All of the other commands work and the pumps/ato/uv all turn on at the times desired. Please help this newbie. Thank you in advance. This community is always so kind and helpful.
Here is the virtual outlet programing:
vFEED:
Set OFF
If Time 07:30 to 07:33 Then ON
If Time 17:05 to 17:08 Then ON
ATO:
Fallback ON
Set ON
If Output vFEED = ON Then OFF
If Output vWaterChange = ON Then OFF
Defer 008:00 Then ON
Return Pump:
Fallback ON
Set ON
If Output vFEED = ON Then OFF
If Output vWaterChange = ON Then OFF
Defer 005:00 Then ON
Skimmer:
Fallback ON
Set ON
If Output vFEED = ON Then OFF
If Output vWaterChange = ON Then OFF
Defer 008:00 Then ON
AFS:
Set OFF
If Output vFEED = OFF Then OFF
OSC 000:00/000:30/000:30 Then OFF
As stated, I'm running into an issue where I've obviously screwed up the programing on my AFS, and it is spinning every 30 seconds (don't worry, I moved it over a paper plate until I figure this out). I'd like to have all of my pumps, skimmer, ATO, etc. turn off when the feeding cycle starts and stay off for either 5 or 8 minutes after feed cycle is complete. I need the AFS to spin 3 times for each feeding and was using the OSC command, but I'm sure I've messed up somewhere. All of the other commands work and the pumps/ato/uv all turn on at the times desired. Please help this newbie. Thank you in advance. This community is always so kind and helpful.
Here is the virtual outlet programing:
vFEED:
Set OFF
If Time 07:30 to 07:33 Then ON
If Time 17:05 to 17:08 Then ON
ATO:
Fallback ON
Set ON
If Output vFEED = ON Then OFF
If Output vWaterChange = ON Then OFF
Defer 008:00 Then ON
Return Pump:
Fallback ON
Set ON
If Output vFEED = ON Then OFF
If Output vWaterChange = ON Then OFF
Defer 005:00 Then ON
Skimmer:
Fallback ON
Set ON
If Output vFEED = ON Then OFF
If Output vWaterChange = ON Then OFF
Defer 008:00 Then ON
AFS:
Set OFF
If Output vFEED = OFF Then OFF
OSC 000:00/000:30/000:30 Then OFF