AI Axis feedmode question

[Pvtgloss]

I have a 9gal deskmate Florida. If I turn on feed mode the pump goes down to 1%.
The problem is that the flakes still go directly down the overflow. Especially since the feeding port on the lid is right next to the over flow. I did turn the loud around to the opposite corner even though it's a pain to get to the port because the AI Blades are in the way-ish. Flakes still go down overflow.
Is there anyway to have feed mode turn off the pump 100%.?
I know I can manually turn it off 100% a d manually turn it back on. I'm hoping I can utilize the feed mode timer so it'll turn on automatically.

 

[ryanjohn1]

You could switch to pellets that sink a bit more. Personally I don’t reduce pumps at all when feeding.

 

[Spartan037]

You are using the Florida 9 Gallon peninsula, AI Axis & Blades together? I want to do this. Do you have any pics of the setup? And how do you control everything controller or just water changes?

 

[Pvtgloss]

You are using the Florida 9 Gallon peninsula, AI Axis & Blades together? I want to do this. Do you have any pics of the setup? And how do you control everything controller or just water changes?

I'll take a picture when I get home. I'm out of town.
I use the Axis for feed mode. Everything so wants to go straight down the overflow though.
For water changes I have Everything plugged into a kasa wifi strip.
Ato is a jlj nano
Everything works pretty good.

 

[Spartan037]

Thanks. I am debating between this and a Hello Reef.