Doesn't look like anything. The dashboard is showing that the "REFUGE" switch is currently (in your screenshot) in the "ON" position, so there are several possibilities I can think of:What am I doing wrong.
1) The light itself is either off (if there is a switch) or the light itself is faulty
2) The outlet you're working with above may be a "virtual" outlet and is not actually controlling a plug
3) The outlet the fuge light is plugged into is different than the one you're programming.
4) The outlet you're using is, itself, faulty
Can you try the following (in order):
- Try resetting the Apex; turn it off, let it sit for 1min, then turn it back on. Test the light again.
- Plug the light directly into a non-controlled outlet (eg; the wall). Does it turn on? If not; look for an on/off switch; else the light (or it's power source) is likely bad.
- Plug the light back into the Apex and set the virtual switch to "on". Does the light actually turn on? If not, check (on the "Outputs" screen) to see what the "type" is for your outlet (it should be "outlet"; not "virtual"). If it's "outlet", check to be sure the number matches the one you've plugged the light into.
- Try using a different outlet; copy your "Advanced" programming into that outlet's configuration and see if that works (if it works, the outlet itself is possibly bad).