Apex Alarm off Notifications

[puffy127]

Any know what is going on here? I haven't changed anything in the alarm code and this just started.

Here's my alarm code:
Set OFF
If Output Alk_Low = ON Then ON
If Output Ca_Low = ON Then ON
If Output Return_Pump = OFF Then ON
If Output Floor_Wet = ON Then ON
If Output SkimmateHigh = ON Then ON
If Output ATO_Empty = ON Then ON
If Alkx11 < 6.00 Then ON
If Alkx11 > 10.70 Then ON
If Cax11 > 580 Then ON
If Error Trident_11_3 Then ON
If Cax11 < 300 Then ON

 

[Sisterlimonpot]

The leak detection sensor says it detects water... are you saying it's dry?

 

[puffy127]

Yes, it's dry. Even if it were wet, wouldn't the alarm just stay on? Or even toggle off and on if it were just a little bit wet? But here it's just constant off notifications without a corresponding on alarm. Even when an alarm is on, it usually only nags me hourly. Not every few seconds. And usually alarm off notifications are just once until there is another alarm on notification.

 

[areefer01]

How does the code look if you use the task for atk leak detection? I do not run one so not sure. You could do a quick search on Suncrestreef as he had several tutorials here an on Neptunes forums. Maybe there is something there? Example below.

Sorry I don't have an answer.
https://www.reef2reef.com/threads/need-help-with-leak-sensor-on-apex.763977/post-8036318

 

[A_Blind_Reefer]

I didn’t hear any defer statements. Is it possible that something is teetering at a trigger value?

Edit. That is if the issue is an alarm cycling on and off. Or is it that something isn’t alarming?

 

[puffy127]

Thanks all. I found this post from Suncrestreef:
https://www.reef2reef.com/threads/apex-alarm-on-off-with-no-explanation.834791/
Seems like it was toggling on/off so fast that apex wasn't logging the on before it turned off. I turned off the virtual outlet monitoring that sensor and no more alarms!

Now I need to figure out if the sensor went bad as the floor is completely dry.