- Joined
- Jan 12, 2019
- Messages
- 975
- Reaction score
- 1,199
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
To Answer your question it’s saying it will be off normally, to cut on when ato hi is opened , to be off if ato lo is closed, to not run more than 5 minutes, to wait 10 seconds to cut off after being on, to continue for an extra 4 seconds after triggered off and to only run 1x every 60 minutes
Shouldn’t it be on when the low is open and off when it goes past the low?To Answer your question it’s saying it will be off normally, to cut on when ato hi is opened , to be off if ato lo is closed, to not run more than 5 minutes, to wait 10 seconds to cut off after being on, to continue for an extra 4 seconds after triggered off and to only run 1x every 60 minutes
Yes that is correct.Shouldn’t it be on when the low is open and off when it goes past the low?
I don’t think I flipped the switches around...I did a test and held the lower switch in the water and th e higher switch out. On the dashboard, the ATO_Low was open and the higTo Answer your question it’s saying it will be off normally, to cut on when ato hi is opened , to be off if ato lo is closed, to not run more than 5 minutes, to wait 10 seconds to cut off after being on, to continue for an extra 4 seconds after triggered off and to only run 1x every 60 minutes
Should I change the ATO low with the ATO high in the programming?Yes that is correct.
OK hows this?Yes that is correct.
Yes that would be correctOK hows this?
Ok ill do thatYes that would be correct
Then after that verify it’s working correctly.Ok ill do that
How do i set it to send an alarm if the water is too high? Yesterday there was a malfunction with the entire DOS and the water level was literally the same height as the rim of my tank. If the alarm on the atk had worked then i would have noticed sooner...Then after that verify it’s working correctly.
Go to your email alarms and program:How do i set it to send an alarm if the water is too high? Yesterday there was a malfunction with the entire DOS and the water level was literally the same height as the rim of my tank. If the alarm on the atk had worked then i would have noticed sooner...
Thanks ill try thatGo to your email alarms and program:
If ATO_Hi closed then on
This should trigger your alarm. I receive a text if one of my alarms trigger
Check and make sure you didn’t program that as your alarmThanks so much for everything you half already done to help me unfortunately I have another problem... apex keeps sending this don’t know what it means..
I also used the task configuration for that but I’ll check nowCheck and make sure you didn’t program that as your alarm
Check and make sure you didn’t program that as your alarm
It should be if Ato_hi is closed then on not ato_lo