Apex code for roller mat power

[becon776]

Hi guys. So my return is acting weird. Out of nowhere it will almost shut itself down. Power reports say 3w. Normally runs at 64. When this happens I shut pump off then back on again all is fine BUT i notice i have burned thru half a roll of filter mat. I know I know get a better return. Also id rather not mess with the float valves as all are set perfect for the status quo. But for right this is the code I came up with. Is this right? If there is a cleaner way?

Fallback ON
Set ON
If Output Jeboa_Return = OFF Then OFF
Defer 002:00 Then ON
Fallback OFF
Set ON
If Output Jeboa_Return watts < 20.0 Then OFF
Defer 010:00 Then ON
If Power Apex Off 001 Then OFF
Defer 002:00 Then ON
If FeedA 005 Then OFF
Defer 002:00 Then ON

 

[becon776]

Yeah brain hurts, too many fallback and sets and defers lol.