Apex coding for complete beginner

[SoCalReefer19]

First and foremost, apologies for any redundant questions. I definitely plan on spending hours researching to set up my system properly but I’m struggling with two of the more critical functions of my apex and I’m hoping for more rapid results this way. First is my heater. It’s plugged in and I’ve selected the on/off temps in fusion and the slider is on auto. Here is my main question *IS IT REQUIRED TO ENTER CODE IN THE CONFIGURATION AREA WHERE YOU CAN TYPE? Or just make selections on the provided drop down menus? My ATK is also on Auto and installed correctly from a mechanical stand point but it doesn’t run the pump. I’m manually topping off my system right now. Thank you in advance.

 

[TK_KW]

Atk program should look similar to this, if you set it up using wizard.

As far as heater, if your using probe to activate heater outlet on/off. Just set actually heater stat slightly higher than the set point you want. And then let the probe do all the work. I have multiple heaters, but this is the code for one of them. But you could spread temp setting out a little more if you wish.

Atk has coding if feed modes are on(cleaning sump etc) it eont kick on the pmup

 

[SuncrestReef]

Read through my ATK tutorial here: https://www.reef2reef.com/ams/neptu...torials-part-3-automatic-top-off-kit-atk.692/

This is part of my 8-part series on Apex Programming tutorials. This could be very useful for you.