Apex DOS question

[Ktran350]

Hello,

Still pretty new to the Apex DOS. I set up the DOS to dose Alk at 00:00 and cal at 00:30. DOS set has it set up at .5 ml every 10 minutes. When looking at the dosing log, it looks like both Alk and cal are being dosed at the same time after an hr or so. How can I stagger the dosing of these two liquids?

Alk:

Cal:

 

[Ktran350]

Anyone?

 

[Breadman03]

I’ll have to dig a bit for it, but I created a dose profile and used timers for each DOS channel that were offset by 5 minutes, allowing me to dose Triton hourly with a 5 minute delay between each part. Bump or PM tomorrow in case I forget to look it up.

 

[Ktran350]

Great. Thank you!

 

[Breadman03]

Here are some screenshots. One is the DOS outlet code. The next is a timer using OSC, which runs in a separate virtual outlet. Use a different one for each DOS head so that you can change when the doses run. The third screenshot is the amount that will be dosed each time the timer is on.