Hey Everyone,
So i have a apex 2016 lab grade with the older black ERB6 boxes. Two of them. So after installing the second one i noticed it was showing 0 amps. I read only how to calibrate it through Telnet. So i connected to telnet and ran the codes multiple times. At the same time i also zero'd my other amp that was showing ampereage. Now both of them show 0. Sometimes one would work and show 0.9 amps but shortly after go back to zero. You can see the attached screenshot. Both are running lights and pumps etc all turned on. Btw when zeroing instead of unplugging everything is just turn all of them off. So you see how it goes to 1.2 amp and back to 0 constanlty this is without turning anything off. The second box does not show any amps at al. Sometimes like 0.2 this is with 2 radion xr30 connected to it and on. I already posted this on apex forum but no replys for days.
So i have a apex 2016 lab grade with the older black ERB6 boxes. Two of them. So after installing the second one i noticed it was showing 0 amps. I read only how to calibrate it through Telnet. So i connected to telnet and ran the codes multiple times. At the same time i also zero'd my other amp that was showing ampereage. Now both of them show 0. Sometimes one would work and show 0.9 amps but shortly after go back to zero. You can see the attached screenshot. Both are running lights and pumps etc all turned on. Btw when zeroing instead of unplugging everything is just turn all of them off. So you see how it goes to 1.2 amp and back to 0 constanlty this is without turning anything off. The second box does not show any amps at al. Sometimes like 0.2 this is with 2 radion xr30 connected to it and on. I already posted this on apex forum but no replys for days.