APEX FMM Configuration

[shaynasmith]

Hello, I bought an Apex 3 second hand and I thought I had reset it to factory settings but I'm wondering now if there are still items showing that arent valid? I have one FMM module plugged in for my ATK with ports showing as ATOLO, ATOHI for the optical sensors and then the optical sensor showing as SUMPHI plugged into port 3. I have my leak detector plugged into the 4th port however when I am on fusion I'm not sure what one it is as its showing me SWX4-1 through 4 with a different aquabus address. The previous ports show "Aquabus address 1" and all others show "Aquabus address 4". Any ideas why my apex is showing so many extra ports or which one could be for the leak detector?

 

[Dan_P]

Hello, I bought an Apex 3 second hand and I thought I had reset it to factory settings but I'm wondering now if there are still items showing that arent valid? I have one FMM module plugged in for my ATK with ports showing as ATOLO, ATOHI for the optical sensors and then the optical sensor showing as SUMPHI plugged into port 3. I have my leak detector plugged into the 4th port however when I am on fusion I'm not sure what one it is as its showing me SWX4-1 through 4 with a different aquabus address. The previous ports show "Aquabus address 1" and all others show "Aquabus address 4". Any ideas why my apex is showing so many extra ports or which one could be for the leak detector?

I’m surprised this didn’t get an answer. Did you figure it out yet?