Apex fusion problem

[paraletho]

I don't use my fusion that much for everyday stuff. I went to check my graphs the other day when I was recording some parameters and my amp graph has been flatline at 0 for a week and a half. The only known problem is that power goes on and off a lot around here and I am always having to reboot. Curious also that my light has a problem that started about the same time. A six bulb older model Power Module about the same time two bulbs started not firing. It isn't the bulbs did the swap test. Funny thing is it is one bulb from two different channels. One from the 4 bulb and one from the 2 bulb. Does this tell me it isn't a ballast? Some one mentioned maybe a grounding issue? Electrician I am not.

 

[vhuang168]

Start a support ticket

 

[Daniel@R2R Verified Admin]

Start a support ticket

This is what I would probably recommend as well. Did you reset the apex? Sometimes that fixes issues. #apexusers

 

[iemsparticus]

New problem to me. Start a ticket. :)

 

[paraletho]

I went ahead and rebooted and it cured it. I had done this previously a couple of times and everything was coming back except amperage. the last time did it and no issues since. Now I just have to deal with Harvey and 15-30 inches of rain predicted.