Yesterday my Klir stayed on all day until the brand new fleece roll was 100% used due to the sensor possibly retaining enough moisture to keep it on. It was a pain rolling it back up. I think I want to bypass the sensor altogether. The motor will simply turn on if it’s plugged in differently. I found that out by not having any instructions with this thing. So, I want to just remove the sensor and use my apex to turn it on for 10 seconds, then off every 12 hours. Any suggestions for this programming? Assuming osc?
Apex programming help for Klir
- Thread starter Cflow
- Start date
- Tagged users None
Alchameth
Active Member
Check out SuncrestReef s Articles for all your Apex programing needs...
www.reef2reef.com
Fallback OFF
OSC 000:00/000:10/720:00 Then ON
Neptune Apex Programming Tutorials, Part 2: Timers
Part 2 of a series on learning how to program your Neptune Apex. Today's article is all about timers: OSC, If Time, DOW, Defer, When, and Min Time.
www.reef2reef.com
Fallback OFF
OSC 000:00/000:10/720:00 Then ON
Cflow
Well-Known Member
- Joined
- Jan 9, 2016
- Messages
- 553
- Reaction score
- 202
Check out SuncrestReef s Articles for all your Apex programing needs...
Neptune Apex Programming Tutorials, Part 2: Timers
Part 2 of a series on learning how to program your Neptune Apex. Today's article is all about timers: OSC, If Time, DOW, Defer, When, and Min Time.
Fallback OFF
OSC 000:00/000:10/720:00 Then ON
Thank you
Similar threads
