API MelaFix Skimmer problem

  • Thread starter Thread starter Neo Jeo
  • Start date Start date
  • Tagged users Tagged users None

Neo Jeo

Valuable Member
View Badges
Joined
Dec 6, 2017
Messages
2,475
Reaction score
2,858
Location
East Michigan
What state or country do you live in
Michigan
Rating - 0%
0   0   0
I used melafix marine to solve a bacterial problem on my fish . I stopped using the product two weeks ago and have done two water changes and replace the carbon let the carbon run for a few days but my skimmer still goes crazy I understand that that is a side effect of the product and it also says that on a bottle but seriously how long will it last I cannot get my skimmer into check after I use the product. my tank still has a slight smell of that medication so I’m assuming it’s still in the water somewhere .

Any suggestion ?
 
The main ingredient of melafix, tea tree oil, is insoluble in water so may take a while.

I’d go with more water changes, increasing GAC contact time and emptying your skimmer cup often.
 
The main ingredient of melafix, tea tree oil, is insoluble in water so may take a while.

I’d go with more water changes, increasing GAC contact time and emptying your skimmer cup often.

GAC?
 
Cool. I guess it will take time lol. Doing water change again.
 
Good luck! Going forward always best to treat outside your display tank - though we all know that's often easier said than done...
 
Good luck! Going forward always best to treat outside your display tank - though we all know that's often easier said than done...

True.. it was a natural so I figured it wasn’t too bad ;)
 
I’m on my 3rd water change and I have replaced the carbon. I let my skimmer run and I keep getting crazy bubbles. It will not skim.

Any advice? Do I need to clean the skimmer? It’s only been in the tank little over a month
 
I just added 2 cups more of carbon and put it on a bag under my filter shock
 
are you emptying the skimmer cup or letting it overfill in the tank? Also was the skimmer broken down?

Do you have a carbon reactor or add in bags?

I’d take out the skimmer for a couple days and let carbon work, you can clean the skimmer in the meantime. Perhaps increase flow a bit to compensate for aeration loss.
 
are you emptying the skimmer cup or letting it overfill in the tank? Also was the skimmer broken down?

Do you have a carbon reactor or add in bags?

I’d take out the skimmer for a couple days and let carbon work, you can clean the skimmer in the meantime. Perhaps increase flow a bit to compensate for aeration loss.

I’m letting the skimmer overflow and it drains back into the sump. I have a reactor with gfo and I just addded and extra bad to my shock area. The skimmer was broken in if that’s what you’re asking. It was skimming great until I added that med.
 
I think your skimmer picks up the oily residue and then dumps it back in the sump. If you can try putting the cup on and emptying it that would help remove it. If the cup would be overflowing too much I’d go without skimmer for a few days.
 
I think your skimmer picks up the oily residue and then dumps it back in the sump. If you can try putting the cup on and emptying it that would help remove it. If the cup would be overflowing too much I’d go without skimmer for a few days.

Ya it’s overflowing like crazy. Fills the cup in seconds. I have waited 3 weeks lol
 
Seems like that extra bag of carbon worked. I ran my skimmer and let it drain back into the tank. Now it's finally acting normal. It already has a 1" of dark green slime and my algae that was growing on my sand bed is gone lol. Skimmers really do work!

Thanks for the help
 
Seems like that extra bag of carbon worked. I ran my skimmer and let it drain back into the tank. Now it's finally acting normal. It already has a 1" of dark green slime and my algae that was growing on my sand bed is gone lol. Skimmers really do work!

Thanks for the help

Hey I just starting treating with Melafix too. Cloudy eye on new fish after I picked it up from qt guy. Unfortunately notice after he was in the display and didn’t want stress them all trying to catch the sick fish.

How long did you treat for ? Did you run carbon in a reactor or just in bags? I have a carbon reactor that I turned off as per instructions.

I took gfo off too not sure if I can run it. My phosphates are still high. 0.84.
 
Hey I just starting treating with Melafix too. Cloudy eye on new fish after I picked it up from qt guy. Unfortunately notice after he was in the display and didn’t want stress them all trying to catch the sick fish.

How long did you treat for ? Did you run carbon in a reactor or just in bags? I have a carbon reactor that I turned off as per instructions.

I took gfo off too not sure if I can run it. My phosphates are still high. 0.84.

You can’t run carbon or gfo when using that product. I had to turn my protine skimmer for like 3 weeks . I used it for 7 days I don’t know about your situation tho. After I did many water changes and ran extra carbon to get it out.
 
You can’t run carbon or gfo when using that product. I had to turn my protine skimmer for like 3 weeks . I used it for 7 days I don’t know about your situation tho. After I did many water changes and ran extra carbon to get it out.

Did you run carbon in media bags or reactor?
 
Thanks for asking that question! I did the same you did and now I know I need to:
-frequent water changes
-empty the skimmer (oily water)
-add extra carbon in bags and reactor

Never doing this again!
 

TOP 10 Trending Threads

HOW DO YOU HANDLE HOLIDAY DECORATING AROUND YOUR REEF?

  • I decorate the tank or stand

    Votes: 1 4.5%
  • I decorate AROUND the tank or stand

    Votes: 4 18.2%
  • I add one small seasonal touch but keep it very basic

    Votes: 0 0.0%
  • I take a holiday photo, but don’t decorate the space

    Votes: 0 0.0%
  • I leave the reef area as it is

    Votes: 13 59.1%
  • We don’t decorate for the holidays

    Votes: 4 18.2%
  • Other (Post in the comments)

    Votes: 0 0.0%
Back
Top
Home
Post thread…
Market
What's new