Apogee MQ-200 par meter tips

Martingale

Active Member
View Badges
Joined
Sep 10, 2019
Messages
249
Reaction score
107
Location
St Leonard, Maryland
Rating - 100%
2   0   0
Recently got a hold of a par meter, and I'm looking for some generic instructions on usage. I'm aware they reccomend a 1.08 correction factor for underwater, and that this model isn't as sensitive on the blue spectrum as the 500/501.

I have LEDs, so I assume I'm correct to use the "SUN" mode? Also, given the sensors orientation matters for intensity of the reading, I assume it's best to keep the sensor parallel always facing straight up in the tank for more consistent readings?

I don't expect precise measurements here, just trying to get a ballpark idea with placements. Any tips/thoughts welcome!
 
Yes, have it on Sun. It does a consistent job and that's all that is really needed.

Dana Riddle had a good article on in Advanced Aquarist comparing it's testing results on LEDs to a LiCor.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new