Appropriate container for dosing Sodium Hydroxide?

Nerdist Aquarist

Active Member
View Badges
Joined
Jul 12, 2019
Messages
164
Reaction score
126
What state or country do you live in
Florida
Rating - 0%
0   0   0
I'm going to start dosing Sodium Hydroxide in addition to my 2 part mix in effort to raise pH. What's a good container to keep the solution in? Apparently glass is a no no, and some plastics are too. What about acrylic?
 
If your mixing dry sodium hydroxide with water, I'd only do it in glass. This reaction is very exothermic....it gets hot. Not sure I'd trust plastics. I'd get a glass bottle with a glass stopper.

reagent bottle.jpeg
 
I'm reading glass is not recommended as it does react.
 
I just kept mine in a plastic juice jug. You aren't dealing with fluorine based acids. Its lye.

It gets warm when mixed. So....you keep it immersed in cold water when mixing it. No big deal.

Just a warning, but I've tried dosing sodium hydroxide and found it full of other stuff like phosphate. If you are dosing it try to get pharma grade.
 
Polyethylene and polypropylene are not impacted by high pH. Just make sure you do not get it too hot from the heat of dissolution. Avoid polycarbonate.
 
Polyethylene and polypropylene are not impacted by high pH. Just make sure you do not get it too hot from the heat of dissolution. Avoid polycarbonate.
How would you recommend keeping polyethylene containers cool while mixing the sodium hydroxide and sodium sulfate? I could set my polyethylene containers on ice packs. Would mixing slowly help?
 
How would you recommend keeping polyethylene containers cool while mixing the sodium hydroxide and sodium sulfate? I could set my polyethylene containers on ice packs. Would mixing slowly help?

Just make sure they are nearly full of cool water, rather than adding a little water to the solid.
 
Glass is fine at room temperature. I've stored solutions of sodium hydroxide in glass for years (10+ years). The stopper should be plastic since the glass stopper can become frozen over time.
 
Last edited:
@Randy Holmes-Farley I didn't quite understand from above. Would a borosilicate beaker be ok for mixing (not storing) your standard (or 1.5x) solution your sodium hydroxide solution?
 
@Randy Holmes-Farley I didn't quite understand from above. Would a borosilicate beaker be ok for mixing (not storing) your standard (or 1.5x) solution your sodium hydroxide solution?

Yes. The hydroxide concentration is not high enough to cause rapid etching. I just did not want folks to think of glass as inert. A little silicate, if any releases, will not hurt anything. I regularly dosed it. Other things in glass are too low to worry about or nontoxic (like borate).
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.3%
  • Fish or coral food

    Votes: 5 5.4%
  • Test kits or reagents

    Votes: 10 10.8%
  • Filter media or replacement fleece

    Votes: 5 5.4%
  • RO/DI filters or supplies

    Votes: 14 15.1%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 11 11.8%
  • I keep a backup of everything

    Votes: 24 25.8%
  • Other (Post in the comments)

    Votes: 7 7.5%
Back
Top
Home
Post thread…
Market
What's new