Aqua medic controller

[dmcoates]

so I just replumbed my sump so I could run a minfold and it's all hard plumbed in. After I installed my new Aqua Medic DC runner 9.1 I turned it on. I get nothing from the pump, only the middle half of the lights are lite up on the controller. So I used the controller of the old DC pump I removed to get water moving. I am not sure that brand of pump it was, it came with the cadlights tank. Dose anyone know if that controller will work until I can get a replacement? The one that came with the aqua medic pump says it's 1-10 volts , not sure the voltage on the other one. Are all D.C. Pump controllers the same? Dose anyone have any advice. Thanks

 

[Reefing Madness]