Aquatic life hybrid t5.... maxspect Razor

RUGDOG · Jan 17, 2019

Anybody played with mounting a razor in one of these units?
I have seen where some folks have used the cross bars and mounted some LED’s on them that weren’t the ones it is designed for with the hanger screw in points on the LED?
Thanks!

nautical_nathaniel · Jan 18, 2019

RUGDOG said:
Anybody played with mounting a razor in one of these units?
I have seen where some folks have used the cross bars and mounted some LED’s on them that weren’t the ones it is designed for with the hanger screw in points on the LED?
Thanks!

The Razor is pretty wide due to the cooling fins, it may make the whole setup super large. I suspect you would need to fabricate special brackets to hold it as well since the T5 Hybrid was designed for Radions and Kessils

RUGDOG · Jan 18, 2019

The center light run of razor would sit in there I think. There are screws on that side that are 6 1/4 inches apart and I think the cooling wings might stretch out over the fixture??
Don’t know. I bet somebody out there has done it or tried.
I like my old razor and would love to try this combo on a new Little 40 breeder build.

nautical_nathaniel · Jan 18, 2019

RUGDOG said:
The center light run of razor would sit in there I think. There are screws on that side that are 6 1/4 inches apart and I think the cooling wings might stretch out over the fixture??
Don’t know. I bet somebody out there has done it or tried.
I like my old razor and would love to try this combo on a new Little 40 breeder build.

I'd be a bit worried about the light potentially overheating being so close to the heat sinks for the T5 portions of the light in addition to little space for adequate airflow through the cooling fins.