Archon reset

[Jeepguy242]

i just purchased an archon from another member

Can anybody tell me how to reset it so I can get the initial setup page to run.

The instructions say to hold the reset button for 5-10 seconds then connect via WiFi to a network named archon and open a browser and type in 192.168.10.1

I do all that and I get asked for a password. I don’t get the initial setup screen

The original owner says the password should be the default which is DigitalAquatics and password


Anybody have any ideas

 

[Jeepguy242]

crickets......

 

[n2585722]

In the newer version of software there is no need for the setup page. it is a menu option. You can get to it either by the Archon's hot spot with any device with a webpage or via your network if it is aready setup for you network. See my buid page it goes over the Archon and the inital setup. The link is in my signature. The Controller starts on post #35 on the second page. If you have any questions I will answer them as best I can.

 

[Jeepguy242]

In the newer version of software there is no need for the setup page. it is a menu option. You can get to it either by the Archon's hot spot with any device with a webpage or via your network if it is aready setup for you network. See my buid page it goes over the Archon and the inital setup. The link is in my signature. The Controller starts on post #35 on the second page. If you have any questions I will answer them as best I can.

thanks for your answer, but i could not get to any pages because it kept asking me for a password... tried every way to get in... no luck.... sent it back and bought an apex....