ATI powermodule came in!

[Diesel]

Any specific recommendation to start off the LED percentage? I was doing 40% with Radions before. Not sure how T5 + LEDs would work? Maybe start at 20-30%?

The leds on these units are nothing compared with Radions.
I have mine set at 100%.
Can't remember where I had them when I setup the light.
I know for a fact that I ran only four bulbs in the beginning till I saw some SPS turning green than I knew I had to bump it up a notch.
To be on the save side I think to run your leds at 50% give and take.
If you have a par meter you could compare with the Radions.
But what ever you do don't use the red led's or just maybe for 5%.

 

[SifuMemphis]

The leds on these units are nothing compared with Radions.
I have mine set at 100%.
Can't remember where I had them when I setup the light.
I know for a fact that I ran only four bulbs in the beginning till I saw some SPS turning green than I knew I had to bump it up a notch.
To be on the save side I think to run your leds at 50% give and take.
If you have a par meter you could compare with the Radions.
But what ever you do don't use the red led's or just maybe for 5%.

Awesome, thank you

Since my tank is only 17" tall, I was worried I was going to start bleaching my sps on the top with the 4 bulb T5s / LEDs. I will raise the % of the LEDs from 30 to 50 and go from there.

Thanks for the advice!