Hello dear seawater friends;
I have a specific question regarding the ATI Straton;
I have two ATI Stratons hanging over my pool (160x60x70 deep), and they are 21cm above the water surface. I've set the Straton to 95% light output at the moment, and the following makes me supportive;
I measured the Par value on my SPS with a PAR measuring device, where there are about 15 cm under the water surface, and measure a maximum of 300 Par. But I find that too little at 95% light output, or what do you say? Or am I losing so much light because my water surface is in motion? Would be happy if the experienced people could tell me something about it.
Thanks
I have a specific question regarding the ATI Straton;
I have two ATI Stratons hanging over my pool (160x60x70 deep), and they are 21cm above the water surface. I've set the Straton to 95% light output at the moment, and the following makes me supportive;
I measured the Par value on my SPS with a PAR measuring device, where there are about 15 cm under the water surface, and measure a maximum of 300 Par. But I find that too little at 95% light output, or what do you say? Or am I losing so much light because my water surface is in motion? Would be happy if the experienced people could tell me something about it.
Thanks