Attempting to fix RO DI excessive consumption

  • Thread starter Thread starter lyscer
  • Start date Start date
  • Tagged users Tagged users None
I know I keep bringing this thing back from the dead but I wanted to provide another update. I finally got around to adding a flush valve to my system (2 john guest shut-off valves) so that I can flush the high TDS water that is built up after the membrane when it has been sitting and not producing water since I do bi-weekly water changes. I found that the TDS after sitting for a week or two was coming out at 105ppm I flush it for 5-10 minutes until it is down to ~22ppm since I don't see it go much lower after hours of production I know this is in a low state so I then open the valve to let the water start going through the DI canisters. I'm thinking that this will help extend the life of my DI resin significantly since I wont be pushing unnecessary high TDS water through the 1st canister.

uaMe843h.jpg
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.1%
  • Fish or coral food

    Votes: 5 5.3%
  • Test kits or reagents

    Votes: 10 10.6%
  • Filter media or replacement fleece

    Votes: 5 5.3%
  • RO/DI filters or supplies

    Votes: 15 16.0%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 11 11.7%
  • I keep a backup of everything

    Votes: 24 25.5%
  • Other (Post in the comments)

    Votes: 7 7.4%
Back
Top
Home
Post thread…
Market
What's new