Kooma
Well-Known Member
I’ve been experimenting with a concept I haven’t see much of, base load heating tank based on its thermal losses.
I have a 225 gallon system and use a 250w and 300 watt Ehiem heater on a Inkbird. My apex backs it up. I was never happy with the range that the Inkbird would heat to, and found the Inkbird can be +/- 1.5-2F off from the apex and other sources. The tank would drift low of the desired temp as per apex and then crank on the heat until it would overshoot the desired top.
I calculated the tanks loss around 68 watts and have added a 50 watt heater with a temp control by the apex to the tank. It’s not enough that it would overheat the system, but recently now that we are in heating season, has kept the tank very stable. Previously I would see swings of 75.8-77.1F when the Inkbird is set to 76-76.5f.
We had a recent heat spell and the tank rose on its own, but it’s been for a few days and I logged in surprised to find a 0.25F swing. INCREDIBLE!
I really want to build out a way to simulate ocean temp changes in an accurate way for coral spawn events and general care. I’d like to do something similar for lighting as well.
Wanted to share some progress :)
I have a 225 gallon system and use a 250w and 300 watt Ehiem heater on a Inkbird. My apex backs it up. I was never happy with the range that the Inkbird would heat to, and found the Inkbird can be +/- 1.5-2F off from the apex and other sources. The tank would drift low of the desired temp as per apex and then crank on the heat until it would overshoot the desired top.
I calculated the tanks loss around 68 watts and have added a 50 watt heater with a temp control by the apex to the tank. It’s not enough that it would overheat the system, but recently now that we are in heating season, has kept the tank very stable. Previously I would see swings of 75.8-77.1F when the Inkbird is set to 76-76.5f.
We had a recent heat spell and the tank rose on its own, but it’s been for a few days and I logged in surprised to find a 0.25F swing. INCREDIBLE!
I really want to build out a way to simulate ocean temp changes in an accurate way for coral spawn events and general care. I’d like to do something similar for lighting as well.
Wanted to share some progress :)
