Battle with low PH

  • Thread starter Thread starter aqua reef
  • Start date Start date
  • Tagged users Tagged users None

aqua reef

New Member
View Badges
Joined
Feb 16, 2014
Messages
2
Reaction score
0
Location
Singapore
Rating - 0%
0   0   0
After ignoring my tank for about a year, i have just started to restock my tank. My current tank total volume is around 600L, and i run a calcium reactor. Until recently someone pointed to me that my PH of 7.7 is extremely low and need to look at. I currently run a calcium reactor and i attribute this low ph to the calcium reactor. So in a harsh move, i decomm the calcium reactor and switched to Tropic Marine All-For-Reef dosing. True enough, the ph went up to 7.9 in the day, and around 7.8 at night. To further increase the PH, i decided to add in a kalkwasser reactor to dose at night. I use a kamoer continuous dosing pump and i drip 5ml/min of kalkwasser into the sump at night. The total volume of kalk for the overnight dripping works out to be around 5L/night. However, i don't see a dent in the ph at all. May be a 0.01 or 0.02 increase in ph.

Since i only started doing this in the last 1 week, do you think the PH will gradually improve over the next few months if i keep doing the kalk dosing at night? Or would it just stay like this?
 
i run an air tubing from outside the house to my skimmer intake. Other than that, the tank is indoor, and not a lot of ventilation going on.
 
Look at getting a co2 meter from amazon. Measure inside and outside the house. Also consider using sodium hydroxide drip instead of kalk to bring ph up.
 
Look at getting a co2 meter from amazon. Measure inside and outside the house. Also consider using sodium hydroxide drip instead of kalk to bring ph up.
Just for future reference, the ph to alk contribution ratio is about the same for either. Lye only has the benefit of higher solubility. 1,000/L @25C°
Over 8lbs/gallon.
But, you are adding sodium, and most likely chloride with the calcium supplement when using lye.
 
Just for future reference, the ph to alk contribution ratio is about the same for either. Lye only has the benefit of higher solubility. 1,000/L @25C°
Over 8lbs/gallon.
But, you are adding sodium, and most likely chloride with the calcium supplement when using lye.

Yes, it's primary benefit is getting over the calcium hydroxide solubility limit imposed on kalkwasser additions.

I recommend a 2/3 part system when using it, sodium hydroxide, calcium chloride, and Balling Part C, but other implementations also can be sued:

https://www.reef2reef.com/threads/second-new-diy-two-part-recipe-with-higher-ph-boost.357080/
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 15 18.1%
  • Fish or coral food

    Votes: 5 6.0%
  • Test kits or reagents

    Votes: 8 9.6%
  • Filter media or replacement fleece

    Votes: 4 4.8%
  • RO/DI filters or supplies

    Votes: 13 15.7%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 12.0%
  • I keep a backup of everything

    Votes: 21 25.3%
  • Other (Post in the comments)

    Votes: 7 8.4%
Back
Top
Home
Post thread…
Market
What's new