Brs stage 7 rodi

Jdadams

Active Member
View Badges
Joined
Apr 24, 2021
Messages
416
Reaction score
307
Location
demorest
Rating - 0%
0   0   0
Having an issue with my rodi unit. I bought it used from a local reefer and it work fine. All filters and resin is new and when I run water through it I get a ready of 30 tds going in to the resin on line 3 and line 2 and 1 I’m getting a ready of 1 tds. Why can’t I get zero?
 
OP
OP
Jdadams

Jdadams

Active Member
View Badges
Joined
Apr 24, 2021
Messages
416
Reaction score
307
Location
demorest
Rating - 0%
0   0   0
I had my in and my out mixed up on the resin canisters. But when I switched it and on line 2 I get zero and line 1 I get 2.
 

Quietman

2500 Club Member
View Badges
Joined
May 14, 2017
Messages
3,246
Reaction score
10,850
Location
Indiana - born and bred
Rating - 0%
0   0   0
So your output is 0? It's normal on a 3 stage DI to have low ppm in between stages.

Note that you must have high input (source water) TDS to have 30 ppm after the RO unit. At 95% min efficiency of the RO membrane that's got to be 600 ppm in your source water.
 
OP
OP
Jdadams

Jdadams

Active Member
View Badges
Joined
Apr 24, 2021
Messages
416
Reaction score
307
Location
demorest
Rating - 0%
0   0   0
Line 3 is 30, line 2 was 0 and line was 2. I just changed out the last 2 resin canisters so I will let the new resin run for a bit and see what I get. I’m new to the rodi stuff, I’ve always just baught pre mixed
 

Mastering the art of locking and unlocking water pathways: What type of valves do you have on your aquarium plumbing?

  • Ball valves.

    Votes: 52 48.1%
  • Gate valves.

    Votes: 60 55.6%
  • Check valves.

    Votes: 25 23.1%
  • None.

    Votes: 28 25.9%
  • Other.

    Votes: 9 8.3%
Back
Top