Calcium reactor effluent

rlman41299

Valuable Member
View Badges
Joined
Mar 11, 2012
Messages
1,171
Reaction score
594
Location
san jose
Rating - 0%
0   0   0
Has anyone ever done to split their calcium reactor efflluent output? I mean 2 separate peristaltic pump will be pulling aquarium water through the reactor instead of pushing water through the reactor.
 
Maybe because i am tired, but unsure if would work in this manner.
1.)most peristaltic pumps are not designed for continuous use like this, that is a lot of stretching of the tubes.
2.) not sure would be enough pressure to prime a carx reactor, to begin the pulling of water in.
 
I agree, to what purpose? Feeding two separate tanks would be problematic unless you also spilt the input .... even then there’d be no way to balance input/effluent per tank.
 
IF one pump head isn't enough, so you run one head at full output and adjust the second pump head to control the total through-put and set your Alk level in one tank/system?
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.7%
  • Fish or coral food

    Votes: 5 5.5%
  • Test kits or reagents

    Votes: 9 9.9%
  • Filter media or replacement fleece

    Votes: 5 5.5%
  • RO/DI filters or supplies

    Votes: 14 15.4%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.0%
  • I keep a backup of everything

    Votes: 24 26.4%
  • Other (Post in the comments)

    Votes: 7 7.7%
Back
Top
Home
Post thread…
Market
What's new