calibrating the DOS

Susan Edwards

5000 Club Member
View Badges
Joined
Nov 28, 2016
Messages
5,486
Reaction score
6,225
Location
Tracy, California
What state or country do you live in
California
Rating - 0%
0   0   0
I'm setting up an awc with the apex DOS. When I do the initial calibration, does it matter the length of the hoses, or is it just the amount that fills the container that counts. It's in the garage so I'd rather do all that there than run the tubing 30 feet into the house. I think I can just run water through until it comes out, and then start the calibration, right?
 
It’s what ends up in the container that counts. Just keep in-mind that the length of the tubing, bends, curves, etc. could have a bearing on the output at the end. I would probably calibrate it twice: once before and again after you run the full length of tubing.
 
that is what I thought but figured I'd better confirm as it is for water changes. good plan to run it twice!
 

TOP 10 Trending Threads

HOW WOULD YOU FEEL ABOUT RECEIVING A FISH OR CORAL AS A HOLIDAY GIFT?

  • I’d love one, as long as it’s a species I chose

    Votes: 26 24.8%
  • I’d trust someone who knows my tank to choose

    Votes: 9 8.6%
  • I’d rather get a gift card and pick it myself

    Votes: 42 40.0%
  • I’d prefer gear or supplies instead

    Votes: 2 1.9%
  • Please don’t surprise me with livestock

    Votes: 26 24.8%
  • Other (Post in the comments)

    Votes: 0 0.0%
Back
Top
Home
Post thread…
Market
What's new