I’m stumped and not sure what’s going on..
I purchased a new model apex a couple years back and only recently hooked it up to a new tank build it doing (started cycle Feb10) so I’m relatively new to apex fusion.
I purchased a BRS heater and controller that is plugged into outlet #7. For past month it’s been fine until yesterday when I was doing an ammonia test and the water felt cooler than usual.
My outlet was off, even tho apex fusion said it was set to auto.
So I manually toggled the outlet #7 to ON and the BRS controller turned on saying it was 74 degrees I’m usually at 79.
I checked my programming and everything seems normal. Now I’m perplexed. Can anyone help?
I purchased a new model apex a couple years back and only recently hooked it up to a new tank build it doing (started cycle Feb10) so I’m relatively new to apex fusion.
I purchased a BRS heater and controller that is plugged into outlet #7. For past month it’s been fine until yesterday when I was doing an ammonia test and the water felt cooler than usual.
My outlet was off, even tho apex fusion said it was set to auto.
So I manually toggled the outlet #7 to ON and the BRS controller turned on saying it was 74 degrees I’m usually at 79.
I checked my programming and everything seems normal. Now I’m perplexed. Can anyone help?