- Joined
- May 9, 2018
- Messages
- 39
- Reaction score
- 2
I have a new Apex that is programed and controlled through fusion. I have the Apex ATK set up and used the tasks wizard to set it up. I have the two optical switches set up and they show open and closed correctly. I have two FMM modules but have confirmed that the ATO is programmed to the correct (FMM2) one. I have the FMM2 plugged into power and programmed to be ON Always which it is. When I put the ATO in the "AUTO" position and the switches change state to "CLOSED" it does not switch to "ON". It just stays in the "AUTO" status no matter what? If I manually switch it to "ON" the ATO runs until I manually switch it to "OFF" or "AUTO". This is how the ATO is programmed:
Fallback OFF
Set OFF
If ATOLow OPEN Then ON
If ATOHi CLOSED Then OFF
When On > 005:00 Then OFF
Defer 000:10 Then ON
Defer 000:04 Then OFF
Min Time 060:00 Then OFF
I have run out of ideas on what to do here. Anyone got any ideas or have the same issue?
Fallback OFF
Set OFF
If ATOLow OPEN Then ON
If ATOHi CLOSED Then OFF
When On > 005:00 Then OFF
Defer 000:10 Then ON
Defer 000:04 Then OFF
Min Time 060:00 Then OFF
I have run out of ideas on what to do here. Anyone got any ideas or have the same issue?